Network Guys

Share your knowledge!

Set a Cisco WLC to factory-default and activate webinterface

To set a Cisco WLAN controller to factory default settings, you can connect via console or telnet/ssh to the WLC and type in the following:

(Cisco Controller) > reset system
(Cisco Controller) > recover-config

or you can boot up the device and just press ESC several times to come to the boot menu. Type “5” to clear the configuration. After this you need to activate the webinterface (http and secure https) to configure the WLC by webmanagement:

config network webmode enable
config network secureweb enable

You can also deactivate the http access. Just type in the command with parameter “disable” at the end instead of “enable”.

One Response

Leave a Reply

Click on the button to load the content from jetpack.wordpress.com.

Load content

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Certificates

ekahau Certified Survey Engineer
ATP_wsrgb
ACMP2
suca
Post Categories
Post Archives