Network Guys

Share your knowledge!

Cisco WLC HA failure scenario

Some days ago I tested the HA WLC cluster at one of my customer. This is the environment:

– First WLC (let’s call it “Main-WLC”) with 172.16.1.10 (with shared management IP 172.16.1.30)
– Second WLC (let’s call it “HA-WLC”) with 172.16.1.20 (with shared management IP 172.16.1.30)

We powered-off the Main-WLC, the access points and wireless clients didn’t notice a failure/disconnect. I had only one ping loss. If you go the management webinterface you can see the following:

wlc-ha-active

Peer State: UNKNOWN – Communication Down
Unit: Secondary – HA SKU (Inherited AP License Count = 100)
Redundancy State: Not Redundant

As you can see there is also a switchover history log entry with “Active controller failed”. The copied license is now valid for the next 60 days. In this time you need to replace the “broken” WLC. We powered-on the Main-WLC  and the Peer State changed to “STANDBY COLD”, the active device is still the HA-WLC (the secondary one). There is no prefered master configuration. After the Main-WLC has downloaded the configuration from the HA-WLC it restarts again and the Peer State changed to “STANDBY HOT”:

wlc-standby-hot

To make the Main-WLC the primary WLC, we made a manuell takeover. Connect via SSH to the management ip address (172.16.1.30 in our case) and type in the following command:

redundancy force-switchover

This will force the Main-WLC to be the active one. There was only one ping loss, everything else works fine! You can see this also in the switchover history table as “user initiated”. The secondary HA-WLC will restart, download the configuration and the license storage from the Main-WLC and will restart again. The perfect state of a Cisco WLC cluster would be this:

wlc-ha-cluster-correct

Local State: Active
Peer State: STANDBY HOT
Unit: Primary
Redundancy State: SSO (Both AP and Client SSO)

Feel free to share your thoughts and experience in the comments below!

3 Responses

  1. Nice post. Thank you Michel.
    Did you connect both WLC unit with a straight or crossover cable?
    What OS version are you running on these WLC?

    Thanks

    1. Hi François,

      I’m using the software version 7.6.130.0. Version 8.0 is not recommended for HA at the moment (comment from a Cisco TAC support mail). I used a straight cable.

Leave a Reply

Click on the button to load the content from jetpack.wordpress.com.

Load content

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Certificates

ekahau Certified Survey Engineer
ATP_wsrgb
ACMP2
suca
Post Categories
Post Archives